If your phone is too wet in water then these tips will come to you very much ...
During Holi, people also pour water on each other. During this time if there is a smartphone in your pocket then water also goes in it. This also destroys the electronic parts inside the phone. However, there are some ways to deal with this, whose information we are giving to you here. If this happened to you, you can repair the phone at home by following a few easy steps in such a situation. Follow these steps to follow: 1)If the water is gone in the phone then do not make the mistake of drying it from the dryer. The phone's circuits can melt with the hot air of the drawer. 2)Turn off the phone immediately after the phone is in the water. Also do not use any buttons. If the phone remains on, the danger of shot circuit remains. 3) Do not use the headphone jack and phone's USB port in the phone until the water is completely dry. With this, internal parts can get spoiled. 4) If there are any accessories (battery, memory card etc.) in the phone, separate them. Also put them on a separate towel. It is very important to thoroughly dry all the parts of the phone. 5)Drying the internal parts of the phone is also important. For this you have to take dry rice in a vessel or polythene and keep the phone in it. Let us know that the rice absorbs moisture rapidly. 6) At the same time, in addition to the rice utensil, silica gel pack can also be used. These packs also absorb moisture rapidly. 7) Keep the phone in silica pack or rice vessel for at least 24 hours. When the phone is completely dry, turn it on. Note: If after all this the phone is not turned on or if there is any other problem then take the phone to the service center. |
0 Comments
Follow And Share the Blog.
Emoji